Glacier Bay 67568-1027H2 Installationsanleitung PDF herunterladen (Seite 6)

Operation (continued)

Care and Cleaning

□ To clean, wipe down with a damp cloth and towel dry.

Troubleshooting

Problem Possible Cause Solution

There are leaks from the

handle.

The bonnet nut has come loose and/or the

washer is dirty or damaged.

□ Tighten the bonnet nut.

□ Clean or replace the washer.

The aerator has an

irregular or reduced

water ow.

□ Remove the aerator and

check for debris.

□

Ensure that the rubber washer

is properly installed.

The water will not shut off

completely.

The cartridge is dirty or broken. □ Remove the handle to check

the cartridge.

□ Clean or replace.

The aerator is dirty or mis-tted.

□ Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will

be voided.

NOTE: Refer to the service parts section in this manual for

a detailed drawing showing the location of the parts listed

below.

Removing the quick connector

□ If it is necessary to remove the quick connector

(1), squeeze the tabs (2) on the quick connector

and then pull down to disconnect.

Squeeze

Pull

down

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Keine Kommentare

Glacier Bay 67568-1027H2 Installationsanleitung Seite 6