Glacier Bay VWD2266W-2-HDU Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 10)

Like most appliances, your water dispenser requires periodic maintenance for maximum efciency and performance, and must be cleaned

on a regular basis (i.e. every 4 months). To maintain a hygienic environment within your water dispenser and prevent potential formation

(growth) of bacteria, we strongly recommend regular cleaning. A cleaning kit is available through our Customer Service Department at

1-877-527-0313 or can be ordered online at www.homedepot.com.

CLEANING THE OUTSIDE OF THE WATER DISPENSER

The outside of the dispenser can be wiped clean with a mild soap and water mixture. Never use harsh chemicals or abrasive cleaners. Rinse

thoroughly with clean water, and then dry the surfaces.

CLEANING THE DRIP TRAY

To remove, take the grill (1) off the removable drip tray (F) and rmly lift the tray up,

dislodging it from the guides. Drain and clean. The removable drip tray (F) should be

emptied and cleaned regularly to remove spotting and any mineral deposits. Clean

with a water dispenser cleaning solution (not included) or a mild soap and water

mixture. For tough deposits, add vinegar and let it soak until the deposits come

loose. Then wash, rinse, and dry thoroughly. To replace, put the grill (1) back on

the removable drip tray (F), and slide the tray onto the guides (not dishwasher safe).

CLEANING THE CONDENSER

Vacuum or sweep away the dust from the condenser coils at the back of the dispenser. For best results, you can purchase a brush designed

specically for this purpose from your local appliance store. This will improve cooling and efciency.

DRAINING THE RESERVOIRS

Drain the reservoirs before and after cleaning, when going on long vacations, or if not using the dispenser for long periods of time.

□ Remove the water bottle.

□ Press both dispensing buttons until water no longer comes out.

□ Place a bucket beneath the drain valve on the back of the dispenser.

□ Remove the cap and plug from the drain valve, and let the water ow into the bucket. Replace the cap and plug. (A screwdriver or coin

can be used to help loosen the drain cap.)

□

□ Replace the water bottle (see “Installing the Water Bottle”).

WARNING: Unplug the dispenser before performing any of the following cleaning procedures.

Care and Cleaning

CAUTION: Unplug the dispenser before performing this procedure. Dispense hot water until temperature drops to a safe level to avoid

the risk of scalding.

IMPORTANT: Collect the water in a container, not the drip tray.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Keine Kommentare

Glacier Bay VWD2266W-2-HDU Gebrauchs- und Pflegehandbuch Seite 10